Calibration and Troubleshooting
6-2 M370046-01
Introduction
The calibration of the power supply is software dependent, and there are
no potentiometers to adjust.
Calibration is performed via SCPI commands.
The following items need to be calibrated:
• Programmed voltage
• Voltage readback
• Programmed current
• Current readback
• Non-isolated voltage monitoring
• Isolated voltage monitoring
• Non-isolated current monitoring
• Isolated current monitoring
• Isolated source for analog programming
• Non-isolated source for analog programming
• Over voltage protection system
CAUTION: Equipment damage
Calibration procedures should only be performed by qualified user.
To Next Page
Loading...
