Local Operation
3-36 M370046-01
4. The setting has now been saved to the selected user setting memory
location.
The SCPI command (s) for these instructions are:
*SAV
or
[:]SYSTem[<channel>]:SAVE
Recalling User Setting Memory Locations
This feature recalls settings that were previously saved.
To load user setting memory locations:
1. Turn the mode control knob to the RCL position.
RCL is displayed on the output voltage display with a number
indicating a preset position on the output current display.
2. Turn the Rotary knob/Enter button to select a preset position from
1 to 3.
3. Press the Rotary knob/Enter button.
rCL done is displayed on the output voltage display.
The settings in the selected user setting memory locations have now
been applied to the power supply.
The SCPI command (s) for these instructions are:
*RCL
or
[:]SYSTem[<channel>]:RECall
Three user setting memory locations are available and one user setting
memory location is saved automatically before AC power shutdown. This
user setting memory location will be loaded after AC power is restored.
To Next Page
Loading...
