Step 1: Inspecting and Cleaning
M370046-01 2-3
2
Step 1: Inspecting and Cleaning
Initial Inspection
When you first receive your unit, perform a physical check:
1. Inspect the unit for any scratches and cracks, broken switches,
connectors or displays.
2. Ensure that the packing box contains the 7.5 foot (2.5 m) power cord.
3. If you see external damage or suspect internal damage, contact
Xantrex Customer Service (see Contact Information on page iii) for
an assessment. If the unit is damaged, save all packing materials and
notify Xantrex Customer Service immediately. See packing
instructions in “Return Procedure” on page WA–4.
Periodic Cleaning
The power supply only requires periodic cleaning, not routine servicing.
Whenever a unit is removed from operation, clean the metal surfaces with
naptha or an equivalent solvent, and clean the front panel with a weak
solution of soap and water. Use low-pressure compressed air to blow dust
from components on the printed circuit boards.
To Next Page
Loading...
Need help?
General
