General Troubleshooting
Xerox
®
B215 Multifunction Printer
User Guide
217
Printer Makes Unusual Noises
Condensation has Formed Inside the Printer
Moisture can condense inside a printer when the humidity is above 85% or when a cold printer is in a
warm room. Condensation can form in a printer after it has been sitting in a cold room that is heated
quickly.
Probable Causes Solutions
There is an obstruction or debris inside
the printer.
1. Power off the printer.
2. Remove the obstruction or debris.
Note: If you cannot remove the obstruction or debris, contact a
service representative
Probable Causes Solutions
The printer has been sitting in a cold
room.
• Before operating the printer, allow it to acclimate for several
hours.
• Allow the printer to operate for several hours at room
temperature.
The relative humidity of the room is too
high.
• Reduce the humidity in the room.
• Move the printer to a location where the temperature and
relative humidity are within the operating specifications. For
details, refer to Environmental Specifications.
To Next Page
Loading...
