Windows TCP/IP
235
10.
Select [IPv4 - IP Address], and then [Change Settings].
11.
Use the keypad on the screen to enter an IP address for the machine in the format
“xxx.xxx.xxx.xxx”. Select [Save].
12.
Select [IPv4 – Subnet Mask], and then [Change Settings].
13.
Using the same method as in step 11, enter a subnet mask.
14.
Select [IPv4 – Gateway Address], and then [Change Settings].
15.
Using the same method as in step 11, enter a gateway address.
NOTE: If you do not wish to set the gateway address, leave this field blank.
16.
Select [IPv4 – IP Filter], and then [Change Settings].
17.
Select [Enabled] to filter access to the machine.
NOTE: If you do not wish to use the IP filter feature, select [Disabled].
NOTE: Use CentreWare Internet Services to register the IP addresses which are not
allowed to access the machine. Refer to
CentreWare Internet Services on page 149
.
18.
When you have finished establishing TCP/IP, select [Close] on the [Protocol
Settings] screen.
When [IPv6 Mode] or [Dual Stack] is selected in step 7
8.
Set [IPv6 Address Manual Configuration] to [Enabled].
9.
Select [Manually Configured IPv6 Address], and then [Change Settings].
10.
Use the keypad on the screen to enter an IP address for the machine in the format
“xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx”. Select [Save].
11.
Select [Manually Configured IPv6 Prefix], and then [Change Settings].
12.
Enter an IP address prefix, and then select [Save].
13.
Select [Manually Configured IPv6 Gateway], and then [Change Settings].
14.
Using the same method as in step 10, enter a gateway address.
15.
Select [IPv6 – IP Filter], and then select [Enabled] or [Disabled].
NOTE: If you do not wish to use the IP filter feature, select [Disabled].
NOTE: Use CentreWare Internet Services to register the IP addresses which are not
allowed to access the machine. Refer to
CentreWare Internet Services on page 149
.
16.
When you have finished establishing TCP/IP, select [Close] on the [Protocol
Settings] screen.
To Next Page
Loading...
