8 Printer Environment Settings
236
NetWare
This section explains how to install the machine onto a NetWare network. The following
information is provided:
Information Checklist – page 236
NetWare Environments – page 236
NetWare Installation – page 237
Installation Procedure – page 237
Network Communication Setup – page 238
NetWare Setup – page 239
Computer Setup – page 239
Test Print – page 239
Information Checklist
Before installing the machine onto a network, make sure that the following items are
available or have been performed.
If problems arise during the machine installation, refer to
Problem Solving on page 349
.
for assistance.
NetWare Environments
System configuration
The machine supports NetWare PServer mode in Bindery or NDS. NetWare 3.x/4.x/
5.x/6.x is required to support Bindery. NetWare 4.11 or later is required to support NDS.
In the PServer mode, the machine will function as a print server and print jobs from the
print queue. The machine uses one file server user license.
NOTE: The machine does not support RPrinter mode.
Item By
An existing operational NetWare network is required. These procedures
are not designed to install a NetWare network.
Customer
NetWare versions 3.x, 4.x, 5.x or 6.x Customer
Obtain and record the following information, if required:
• IPv4 address
• Gateway address
• Subnet mask
•Host name
NOTE: Only the IPv4 format is available for addresses.
Customer
Test the machine to make sure that it is fully installed and functioning
correctly.
Customer
Install the print driver. Customer
To Next Page
Loading...
