9 Troubleshooting
Xerox PE220 9-9
Group Not
Available
You have tried to select
a group location
number where only a
single location number
can be used, such as
when adding locations
for a broadcast
operation.
Use a speed dial number or dial
a number manually using the
number keypad.
Incompatible The remote machine
did not have the
requested feature, such
as a delayed
transmission.
This message also
occurs if the remote
machine does not have
enough memory space
to complete the
operation you are
attempting.
Reconfirm the remote
machine’s features.
Line Busy The receiving party did
not answer or the line is
already engaged.
Try again after a few minutes.
Line Error Your machine cannot
connect with the remote
machine or has lost
contact because of a
problem with the phone
line.
Try again. If the problem
persists, wait approximately one
hour for the line to clear and try
again.
Or, turn the ECM mode on. See
ECM Mode (Error Correction
Mode) on page 7-28
.
Load Document You have attempted to
set up a copy or fax
operation with no
document loaded into
the ADF.
Load a document into the ADF
and try again.
LSU Error A problem has occurred
in the LSU (Laser
Scanning Unit).
Turn power off and wait 10
seconds. Turn power on. If the
problem persists, call for
service.
Memory Dial Full The fax jobs queue in
the memory is full.
Cancel unnecessary fax jobs in
the memory.
Display Meaning Suggested Solutions
To Next Page
Loading...
Need help?
General
