10 Specifications
10-8 Xerox PE220
Guidelines for Using Paper
For the best result, use conventional 20 lb (75 g/m
2
) paper. Ensure that the
paper is of good quality, and free of cuts, nicks, tears, spots, loose particles,
dust, wrinkles, voids, and curled or bent edges.
If you are unsure of what type of paper you are loading, such as bond or
recycled paper, check the label on the package.
The following problems may cause print quality deviations, jamming or even
damage to the machine:
NOTE:
• Do not use letterhead paper printed with low-temperature inks, such as
those used in some types of thermography.
• Do not use raised or embossed letterhead.
• The machine uses heat and pressure to fuse toner to the paper. Make
sure that any colored paper or preprinted forms use inks that are
compatible with this fusing temperature (200 °C or 392 °F for 0.1 second).
Paper Specifications
Symptom Problem with Paper Solution
Poor print quality or toner
adhesion, problems with
feeding
Too moist, too rough, too
smooth or embossed;
faulty paper lot
Try another kind of
paper, between 100 ~
400 Sheffield, 4 ~ 5 %
moisture content.
Dropout, jamming, curl Stored improperly Store paper flat in its
moisture-proof wrapping.
Increased gray
background shading/
printer wear
Too heavy Use lighter paper.
Excessive curl problems
with feeding
Too moist, wrong grain
direction or short-grain
construction
Use long-grain paper.
Jamming, damage to
machine
Cutouts or perforations Do not use paper with
cutouts or perforations.
Problems with feeding Ragged edges Use good quality paper.
Category Specifications
Acid content 5.5 pH or lower
Caliper 3.0 ~ 7.0 mils (0.094 ~ 0.18 mm)
To Next Page
Loading...
Need help?
General
