2 Getting Started
2-12 Xerox PE220
Installing Printer Software
NOTE: You must install software using the supplied CD-ROM after you have
set up your machine and connected it to your computer. For details, see
Chapter 5, Printing.
The CD-ROM provides you with the following software:
Programs for Windows
To use your machine as a printer and scanner in Windows, you must install
the MFP driver. You can install some or all the following components:
•
Printer driver
- Use this driver to take full advantage of your printer’s
features.
•
Scan driver
- TWAIN and Windows Image Acquisition (WIA) driver is
available for scanning documents on your machine.
•
ControlCentre
-
Use this program to create phonebook entries and configure
the destination of the scan button. You can also update the firmware of the
machine.
Macintosh Driver
You can print and scan to and from Macintosh operating systems using your
machine.
Linux Driver
You can print and scan to and from Linux operating systems using your
machine.
System Requirements
Your machine supports following operating system.
Windows
98/Me/NT 4.0/2000/XP
The following table shows Windows requirements.
Item Requirements Recommended
CPU Windows 98/Me/NT
4.0/2000
Pentium II 400 MHz or
higher
Pentium III 933
MHz
Windows XP Pentium III 933 MHz or
higher
Pentium IV 1
GHz
RAM Windows 98/Me/NT
4.0/2000
64 MB or higher 128 MB
Windows XP 128 MB or higher 256 MB
To Next Page
Loading...
Need help?
General
