Xinje XD5 - Page 281

280
10: Critical oscillation mode
Bit8：
0: manual control status
1: auto tune end, enter manual
control status
monitoring purposes
only
S3+17
PID max output
0～32767
Internal use
parameters of the
system for
monitoring purposes
only
S3+18
PID min output
0～32767
Internal use
parameters of the
system for
monitoring purposes
only
S3+19
Last time sampling time
0~sampling time (unit: ms)
16-bit no sign,
Internal use
parameters of the
system for
monitoring purposes
only
S3+20
Actual sampling time
space
The value is around the
sampling time
32-bit no sign,
Internal use
parameters of the
system for
monitoring purposes
only
S3+22
Last time user set target
temperature
The value before changing the
target temperature
Internal use
parameters of the
system for
monitoring purposes
only
S3+23
-
-
Parameter is
reserved
The following is the joint address (divided into step setting, critical oscillation setting and
manual control)
Step part (read only parameters, only for monitoring)
S3+24
Actual sampling space
0～4294967296 (unit: ms)
Internal usage
parameters of the
system
S3+26
Operating segment of
auto-tuning PID
0: Preparation stage
1～2: auto tune parameter
collection
3: calculate PID parameters
Internal usage
parameters of the
system
S3+28
Duration of auto-tuning
PID operating
parameters
0～4294967296 (unit: ms)
Internal usage
parameters of the
system
S3+30
Real-time accumulation
of two inflection points
Clear and recalculate the time
when reaching the inflection point
0～4294967296 (unit: ms)
Internal usage
parameters of the
system