PREMIUM E-MOBILITY
YD-EM279
66
5.2.3 Disassembly and installation of the frame baseplate
5.2.3.1 Service tools
●
Cross screwdriver
●
Sleeve 10mm
5.2.3.2 Disassembly and installation
Disassembly
●
The Disassembly and installation method of the front inner fender is the same as that of the bottom plate.
5.2.4 Disassembly and installation Inner fender after
5.2.4.1 Service tools
●
Sleeve 10mm
●
Cross screwdriver
5.2.4.2 Disassembly and installation
Disassembly
●
Park the vehicle on a horizontal road surface to
support the main bracket.
●
Close the key and pull it out.
●
Open the seat cushion and turn off the air switch.
●
Disassembly the center cover underneath. → page
57
●
Disassembly the seat barrel. → page 58
●
Disassembly the side panel left and side panel right.
→ page 61
●
Disassembly screw - arrow - .
●
Disconnect the harness card - arrow A -.
●
Disassembly screw - arrow - .
●
Disassembly the rear inner fender - 1 -.
Installation
Installation is carried out in reverse order of disassembly.
A
A
21
To Next Page
Loading...
