ENGINE
3-19
e. Tighten both locknuts and then slide the rub-
ber cover to its original position.
f. Remove the pin.
g. Turn the main switch to “ON”, check that the
EXUP valve pulley contacts the stoppers (ful-
ly-open and fully-closed positions), and then
check that the notch in the EXUP valve pulley
is aligned with the hole in the EXUP valve
cover.
▲▲▲▲▲▲▲▲▲ ▲ ▲▲▲▲▲▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲▲▲
5. Install:
• EXUP valve pulley cover
T
R
.
.
EXUP valve pulley cover bolt
10 Nm (1.0 m·kg, 7.2 ft·lb)
3
3
dd
c
dd
cc
To Next Page
Loading...
