CHASSIS
3-22
EAS21260
CHECKING THE REAR BRAKE PADS
The following procedure applies to all of the
brake pads.
1. Operate the brake.
2. Check:
• Rear brake pad
Wear indicator grooves “1” almost disap-
peared → Replace the brake pads as a set.
Refer to “REAR BRAKE” on page 4-31.
EAS21280
CHECKING THE FRONT BRAKE HOSES
The following procedure applies to all of the
brake hoses and brake hose clamps.
1. Check:
• Brake hoses “1”
Cracks/damage/wear → Replace.
2. Check:
• Brake hose clamps “2”
Loose → Tighten the clamp bolt.
3. Hold the vehicle upright and apply the brake
several times.
4. Check:
• Brake hoses
Brake fluid leakage → Replace the damaged
hoses.
Refer to “FRONT BRAKE” on page 4-18.
EAS21290
CHECKING THE REAR BRAKE HOSE
1. Remove:
• Seat
Refer to “GENERAL CHASSIS” on page 4-1.
2. Check:
• Brake hoses “1”
Cracks/damage/wear → Replace.
3. Check:
• Brake hose guide “2”
Loose → Tighten the clamp bolt.
4. Hold the vehicle upright and apply the brake
several times.
5. Check:
• Brake hoses
Brake fluid leakage → Replace the damaged
hose.
Refer to “REAR BRAKE” on page 4-31.
6. Install:
• Seat
Refer to “GENERAL CHASSIS” on page 4-1.
EAS21330
ADJUSTING THE REAR BRAKE LIGHT
SWITCH
NOTE:
The rear brake light switch is operated by move-
ment of the brake pedal. The rear brake light
switch is properly adjusted when the brake light
comes on just before the braking effect starts.
1. Check:
• Rear brake light operation timing
Incorrect → Adjust.
2. Adjust:
• Rear brake light operation timing
1
1
2
1
1
2
1
1
To Next Page
Loading...
