REAR SHOCK ABSORBER ASSEMBLY
4-63
• Oil seals
Damage/pitting → Replace.
3. Check:
• Collars
• Spacers
Damage/scratches → Replace.
EAS23270
INSTALLING THE CONNECTING ARM AND
RELAY ARM
1. Lubricate:
• Spacers
• Bearings
2. Install:
• Bearing “1”
(to the relay arm)
• Bearings “2”
(to the connecting arm)
• Oil seals “3”
(to the relay arm)
• Oil seals “4”
(to the connecting arm)
3. Install:
• Relay arm “1”
(to the connecting arm)
NOTE:
Install the relay arm with its “R” mark “a” facing
to the right and its arrow mark “b” facing upward.
4. Tighten:
• Rear shock absorber assembly nut (rear
side)
• Relay arm nut (relay arm and connecting
arm)
Recommended lubricant
Lithium-soap-based grease
Installed depth “a”
8.0 mm (0.31 in)
Installed depth “b”
4.0 mm (0.16 in)
Installed depth “c”
7.0 mm (0.28 in)
Installed depth “d”
0.5–1.0 mm (0.02–0.04 in)
5. Relay arm
6. Connecting arm
7. Rear shock absorber
A. Left side
B. Right side
T
R
.
.
Rear shock absorber assembly
nut (rear side)
40 Nm (4.0 m·kg, 29 ft·lb)
4
6
2
4
3
1
3
4
2
4
5
4
6
2
4
4
2
4
d
c
d
b
b
d
a
b
d
7
A B
R
1
a
b
To Next Page
Loading...
