ENGINE
3-13
NOTE:
Pour the engine oil in two stages. First, pour in
2.5 L of oil, then start the engine and rev it 3 to 5
times. Stop the engine, and then pour in the re-
mainder of the specified amount.
CAUTION:
EC5YU1004
When starting the engine make sure the dip-
stick is securely fitted into the oil tank.
12.Fill: (when engine is disassembled)
• Crankcase and oil tank
(with the specified amount of the recom-
mended engine oil)
NOTE:
After the engine has been disassembled, pour
the specified amount of engine oil into the crank-
case and the oil tank. When pouring engine oil
into the crankcase, pour it into the hole of the re-
moved bolt “1”.
13.Install:
• Engine oil filler cap
14.Start the engine, warm it up for several min-
utes, and then turn it off.
15.Check:
• Engine
(for engine oil leaks)
16.Check:
• Engine oil level
Refer to “CHECKING THE ENGINE OIL
LEVEL” on page 3-11.
17.Check:
• Engine oil pressure
▼▼▼▼▼▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼
a. Slightly loosen the oil gallery bolts “1”.
b. Start the engine and keep it idling until engine
oil starts to seep from the oil gallery bolts. If
no engine oil comes out after one minute, turn
the engine off so that it will not seize.
c. Check the engine oil passages, the oil filter
cartridge and the oil pump for damage or
leakage. Refer to “OIL PUMP” on page 5-81.
d. Start the engine after solving the problem(s)
and check the engine oil pressure again.
e. Tighten the oil gallery bolts to specification.
▲▲▲▲▲▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲▲▲
EAS20860
ADJUSTING THE CLUTCH LEVER
1. Adjust:
• Clutch lever position
(distance “a” from the handlebar grip to the
clutch lever)
▼▼▼▼▼▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼
a. While pushing the clutch lever forward, turn
the adjusting dial “1” until the clutch lever is in
the desired position.
NOTE:
Be sure to align the setting on the adjusting dial
with the arrow mark “2” on the clutch lever hold-
er.
Engine oil quantity
Total amount
5.00 L (5.29 US qt) (4.40 Imp.qt)
Engine
2.2 L (2.33 US qt) (1.94 Imp.qt)
Oil tank
2.8 L (2.96 US qt) (2.46 Imp.qt)
1
T
R
.
.
Oil gallery bolt
4 Nm (0.4 m·kg, 2.9 ft·lb)
Position #1
Distance “a” increases.
Position #4
Distance “a” decreases.
1
To Next Page
Loading...
