ENGINE REMOVAL
5-13
ET5YU1031
REMOVING THE ENGINE
NOTE:
Pass a suitable rod through the hole in the swin-
garm pivot shaft and secure the rod to support
the vehicle.
1. Loosen:
• Down tube spacer bolts
• Engine mounting spacer bolt (rear upper
side)
• Engine mounting spacer bolt (rear lower side)
NOTE:
Loosen the spacer bolts with the pivot shaft
wrench “1”.
EAS23720
INSTALLING THE ENGINE
1. Loosen:
• Engine mounting spacer bolt (rear upper
side) “1”
• Down tube spacer bolts “2”
• Engine mounting spacer bolt (rear lower
side) “3”
2. Install:
• Engine bracket (rear upper side) “4”
(with the ignition coils)
• Engine bracket bolts (rear upper side) “5”
3. Position the engine “6” under the vehicle for
installation.
4. Install:
• Engine “6”
• Engine mounting bolt (rear upper side) “7”
• Engine mounting bolt (rear lower side) “8”
• Down tube “9”
• Down tube bolts (front side) “10”
• Down tube bolts (rear side) “11”
• Down tube nut (rear side) “12”
(temporarily tighten)
• Engine mounting bolt (front lower side) “13”
NOTE:
Do not fully tighten the bolts and nuts.
5. Tighten:
• Down tube spacer bolt “2”
• Engine mounting spacer bolt (rear lower
side) “3”
• Engine mounting spacer bolt (rear upper
side) “1”
• Down tube nut (rear side) “12”
NOTE:
• Tighten the spacer bolts “1”, “2”, “3” to specifi-
cation with a pivot shaft wrench.
• When tightened, the spacer bolts should be flat
against the engine surface.
6. Install:
• Down tube nut (front side) “14”
(temporarily tighten)
• Engine mounting nut (rear lower side) “15”
(temporarily tighten)
• Engine mounting nut (rear upper side) “16”
(temporarily tighten)
Pivot shaft wrench
90890-01485
Frame mount insert wrench
YM-01485
1
T
R
.
.
Down tube spacer bolt
8 Nm (0.8 m·kg, 5.8 ft·lb)
Engine mounting spacer bolt
(rear lower side)
8 Nm (0.8 m·kg, 5.8 ft·lb)
Engine mounting spacer bolt
(rear upper side)
8 Nm (0.8 m·kg, 5.8 ft·lb)
Down tube nut (rear side)
55 Nm (5.5 m·kg, 40 ft·lb)
Pivot shaft wrench
90890-01485
Frame mount insert wrench
YM-01485
To Next Page
Loading...
