HANDLEBAR
4-46
9. Install:
• Front brake master cylinder assembly
• Front brake master cylinder holder “1”
NOTE:
• Align the end of the brake master cylinder hold-
er with the punch mark “a” on the handlebar.
• First, tighten the upper bolt, then the lower bolt.
10.Adjust:
• Throttle cable free play
Refer to “ADJUSTING THE THROTTLE CA-
BLE FREE PLAY” on page 3-7.
T
R
.
.
Front brake master cylinder
holder bolt
10 Nm (1.0 m·kg, 7.2 ft·lb)
Throttle cable free play
3.0–5.0 mm (0.12–0.20 in)
1
a
To Next Page
Loading...
