Yamaha MT-01 T 2005 - Page 182

STEERING HEAD
4-60
2. Install:
• Lower ring nut “1”
• Rubber washer “2”
• Upper ring nut “3”
• Lock washer “4”
Refer to “CHECKING AND ADJUSTING
THE STEERING HEAD” on page 3-25.
3. Install:
• Front brake hose joint bracket “1”
• Front brake hose joint “2”
NOTE:
Make sure that the tab “a” on the front brake
hose joint bracket “1” contacts the side “b” of the
front brake hose joint “2”.
4. Install:
• Upper bracket
• Steering stem nut
NOTE:
Temporarily tighten the steering stem nut.
5. Install:
• Front fork legs
Refer to “FRONT FORK” on page 4-47.
NOTE:
Temporarily tighten the upper and lower bracket
pinch bolts.
6. Tighten:
• Steering stem nut
T
R
.
.
Steering stem nut
110 Nm (11.0 m·kg, 80 ft·lb)
a
1
2
b