7.3 Program Table Operation
7.3.5 SigmaWin+ Procedures
7-19
7
Operation with Digital I/O
2.
Set the acceleration and deceleration rates.
The Same as previous step Check Boxes are selected by default.
To use different values from the previous step, clear the selections of the Same as previous step
Check Boxes and enter the values directly.
3.
Click the OK Button.
This concludes the setting procedure.
Unit Setting Range Default Setting
1,000 reference units/min/ms 1 to 199,999,999 :
If you select the Same as previous step Check Boxes for the starting program step, the set-
tings of the acceleration/deceleration parameters (Pn63E: acceleration rate, Pn640: deceler-
ation rate) that were set before programmed operation was started will be used.
To Next Page
Loading...
Need help?
General
