YASKAWA SGMJV - Page 153

5 Operation
5.4.7 Reference Pulse Inhibit Function
5-46
To use the reference pulse inhibit function, set Pn000.1 to 1, 5, 7 or 8.
Note: Reference pulse inhibit function is effective only with position control.
Parameter Control Method
Input Signal
Used
When Enabled Classification
Pn000
n.

1

Position control (pulse train reference) /INHIBIT
After restart Setup
n.

5

Internal set speed control (contact ref-
erence)⇔Position control (pulse train
reference)
/INHIBIT
n.

7

Position control (pulse train refer-
ence)⇔Speed control (analog refer-
ence)
/INHIBIT
n.

8

Position control (pulse train refer-
ence)⇔Torque control (analog refer-
ence)
/INHIBIT