YASKAWA SGMJV

8.2 Operation in Monitor Mode
8-3
8
Monitor Modes (Un)
8.2 Operation in Monitor Mode
The example below shows how to display the contents of monitor number Un000 (when the servomotor
rotates at 1500 min
-1
)
Step
Display after
Operation
Keys Operation
1
Press the MODE/SET Key to select the monitor mode.
2
If Un000 is not displayed, press the UP or DOWN Key to
select Un000.
3
Press the DATA/SHIFT Key for approximately one sec-
ond to display the data of Un000 (motor speed).
4
Press the DATA/SHIFT Key for approximately one sec-
ond to return to the display of step 1.
MODE
/
SET DATA
/
MODE
/
SET DATA
/
MODE
/
SET DATA
/
MODE
/
SET DATA
/