8.7 Monitor Display at Power ON
When Un number is set using Pn52F, the data of Un that was specified in the panel operator is displayed
when the power is turned ON.
When the 0FFF is set (factory setting), the SERVOPACK becomes the status display mode (bb, run) at power
ON.
SigmaWin+ I/O signal monitor function
I/O signals can also be checked using the I/O signal monitor function of SigmaWin+.
This function can perform output signal output and output prohibited setting. Therefore, sequence of host con-
troller and wiring between the SERVOPACK and host controller, peripheral devices can be checked.
Pn52F
Monitor Display at Power ON
Classification
Setting Range Setting Unit Factory Setting When Enabled
0 to 0FFF − 0FFF Immediately
Setup
To Next Page
Loading...
