YASKAWA SGMJV - Page 283

7.8 Offset Adjustment of Analog Monitor Output (Fn00C)
7-15
7
Utility Functions (Fn)
4
Press the MODE/SET Key to select channel 1 (analog mon-
itor 1) or channel 2 (analog monitor 2) monitor output.
5
Press the DATA/SHIFT Key for less than one second. Zero
adjustment data will be displayed as shown on the left.
6 Press the UP or DOWN Key to change the data.
7
Press the DATA/SHIFT Key for less than one second. The
analog monitor output channel is displayed as shown on the
left.
To adjust a different channel, switch the monitor channel
using steps 4 through 6.
8
Press the DATA/SHIFT Key for approximately one second.
"Fn00C" is displayed again.
Step
Display after
Operation
Keys Operation
MODE
/
SET DATA
/
MODE
/
SET DATA
/
MODE
/
SET DATA
/
MODE
/
SET DATA
/
MODE
/
SET DATA
/