YASKAWA SGMJV

7.12 Write Prohibited Setting (Fn010)
7-21
7
Utility Functions (Fn)
(2) Operating Procedure
Follow the steps below to set "write prohibited" or "write permitted."
Setting values are as follows:
•
"P.0000": Write permitted (Releases write prohibited mode.) [Factory setting]
•
"P.0001": Write prohibited (Parameters become write prohibited from the next power ON.)
Step
Display after
Operation
Keys Operation
1
Press the MODE/SET Key to select the utility function
mode.
2 Press the UP or DOWN Key to select Fn010.
3
Press the DATA/SHIFT Key for approximately one second.
The display shown on the left appears.
4
Press the UP or DOWN Key to set a value:
P.0000: Write permitted (Factory setting)
P.0001: Write prohibited
5
Display blinks
Press the MODE/SET Key to register the value.
The write prohibited settings of parameters are executed.
When the value is registered, the display shown on the left
blinks for about one second.
Note: If a value other than "P.0000" and "P.0001" is set,
"Error" is displayed.
6 The display changes from "donE" to "P.000."
7
Press the DATA/SHIFT Key for approximately one second.
"Fn010" is displayed again.
8 Turn OFF the power and then turn ON again to validate the setting.
MODE
/
SET DATA
/
MODE
/
SET DATA
/
MODE
/
SET DATA
/
MODE
/
SET DATA
/
MODE / SET DATA /
MODE / SET DATA /