YASKAWA V1000

No. Name Description
n3-23
Overexcitation Operation
Selection
Refer to V1000 Technical Manual for details.
n6: Online Tuning of Resistance between Motor Lines
Use n6 parameters to adjust the motor line-to-line resistance while the drive is online.
n6-01
Line-to-Line Motor Resistance
Online Tuning
Refer to V1000 Technical Manual for details.
n8: Permanent Magnet (PM) Motor Control
Use n8 parameters to control the PM motor control.
n8-45
Speed Feedback Detection Control
Gain
Refer to V1000 Technical Manual for details.
n8-47
Pull-In Current Compensation
Time Constant
Refer to V1000 Technical Manual for details.
n8-48 Pull-In Current Refer to V1000 Technical Manual for details.
n8-49
d-Axis Current for High-
Efficiency Control
Refer to V1000 Technical Manual for details.
n8-51 Acceleration Pull-In Current Refer to V1000 Technical Manual for details.
n8-54
Voltage Error Compensation Time
Constant
Refer to V1000 Technical Manual for details.
n8-55 Load Inertia Refer to V1000 Technical Manual for details.
n8-62 Output Voltage Limit Refer to V1000 Technical Manual for details.
n8-63 Output Voltage Limit Gain 1
Refer to V1000 Technical Manual for details.
Note: Available in drive software versions PRG: 1018 and later.
n8-65
Speed Feedback Detection Control
Gain during ov Suppression
Refer to V1000 Technical Manual for details.
Note: Available in drive software versions PRG: 1011 and later.
n8-68 Output Voltage Limit Gain 2
Refer to V1000 Technical Manual for details.
Note: Available in drive software versions PRG: 1018 and later.
n8-87 Output Voltage Limit Selection
Refer to V1000 Technical Manual for details.
Note: Available in drive software versions PRG: 1018 and later.
n8-88
Output Voltage Limit Switching
Current Level
Refer to V1000 Technical Manual for details.
Note: Available in drive software versions PRG: 1018 and later.
n8-89
Output Voltage Limit Switching
Current Hysteresis Width
Refer to V1000 Technical Manual for details.
Note: Available in drive software versions PRG: 1018 and later.
n8-90
Output Voltage Limit Switching
Speed
Refer to V1000 Technical Manual for details.
Note: Available in drive software versions PRG: 1018 and later.
n8-91
Id Limit for Output Voltage Limit
Control
Refer to V1000 Technical Manual for details.
Note: Available in drive software versions PRG: 1018 and later.
o1: Display Settings
Use o1 parameters to configure the digital operator display.
o1-01
Drive Mode Unit Monitor
Selection
Refer to V1000 Technical Manual for details.
o1-02
User Monitor Selection After
Power Up
Refer to V1000 Technical Manual for details.
B.1 Parameter Table
YASKAWA ELECTRIC TOEP C710606 47A YASKAWA AC Drive – V1000 Quick Start Guide
195
B
Parameter List