Yealink VC110 - Endpoint Component Instructions; VC110 All-In-One Unit

User Guide for Yealink VC110 Video Conferencing Endpoint
6
 Ethernet Cable (7.5m)
Locate the Audio In port of the cable hub, and connect it to the Audio Out port of the VCM30
with the 7.5m Ethernet cable. VCM30 video conferencing microphone array can work as the
audio input device for the VC110 endpoint. For more information, refer to Audio Input Device
on page 81.
Note
Endpoint Component Instructions
Before installing and using the VC110 video conferencing endpoint, you need to be familiar with
the following endpoint components, including:
 VC110 All-in-One Unit
 Cable Hub
 VCM60 Video Conferencing Wireless Microphone
 Video Conferencing Phone
 CPE80 Expansion Microphone
 VCM30 Video Conferencing Microphone Array
 VCR10 Remote Control
VC110 All-in-One Unit
The VC110 all-in-one unit integrates the camera, the built-in microphone and the codec into a
unit. VC110 all-in-one unit compresses outgoing video and audio data, transmits this
information to the far end, and decompresses incoming data. It supports 16:9 and 4:3 aspect
ratios. It can be compatible with different audio output devices, and can adapt to the display
devices automatically.
Check the list before installation. If you find that anything is missing, contact your system
administrator.