User Guide for Yealink VC110 Video Conferencing Endpoint
128
The display device prompts “Dongle remove!”. And the icon disappears from the
status bar.
Standby Mode
The VCM60 supports two standby modes: online standby and offline standby.
Online standby:
When registering with dongle successfully, the VCM60 enters online standby mode and
the mute indicator LED changes to green and is in breathing state.
Offline standby:
If VC110 video conferencing endpoint encounters poor signal, wireless interference or is
powered off, the VCM60 may lose connection with the dongle. In this case, the VCM60 will
search the dongle again, and the mute indicator LED fast flashes green. If dongle cannot be
searched in 2 minutes, the VCM60 will enter offline standby mode automatically and the
mute indicator LED slowly flashes orange.
If VC110 video conferencing endpoint starts when the VCM60 is in offline standby mode,
you need to tap the mute button to activate VCM60 to search dongle again.
Muting or Unmuting the VCM60
There is a mute button on the top of the VCM6. If VCM60 works as the audio input device of the
VC110 video conferencing endpoint, you can mute or unmute it in the following scenarios:
If you do not want to have your voice broadcast during a conference, you can tap mute
button to mute the VCM60.
To Next Page
Loading...
