Yealink VC110 - Automatic Sleep Time; Customizing the VC110 Video Conferencing Endpoint; General Settings

Customizing the VC110 Video Conferencing Endpoint
47
Customizing the VC110 Video Conferencing
Endpoint
You can customize your VC110 video conferencing endpoint by personally configuring certain
settings, for example, site name, time & date and language. You can add contacts to the local
directory manually or from the call history.
This chapter provides basic operating instructions for customizing your endpoint. Topics
include:
 General Settings
 Directory
 Call History Management
 Call Protocol
 Bandwidth Settings
 Audio Settings
 Far-end Camera Control
If you require additional information or assistance with your new endpoint, contact your system
administrator.
General Settings
Automatic Sleep Time
The endpoint will enter the sleep mode automatically when it has been inactive for a period of
time (the default period is 10 minutes).
When the endpoint is in sleep mode, it will still accept incoming calls. The display device will
prompt “No Signal”, and the video conferencing phone LCD screen prompts “Sleeping Press any
key to resume”. You can press any key on the remote control or video conferencing phone to
wake the endpoint up. When receiving a call, the endpoint will be woken up automatically.
You can change the automatic sleep time via the remote control or web user interface. You can
also press the sleep key on the remote control to make the endpoint sleep immediately.