Customizing the VC110 Video Conferencing Endpoint
79
You can configure the uplink and downlink bandwidth of the endpoint via the remote control or
web user interface.
Note
To configure the uplink and downlink bandwidth via the remote control:
1. Press (Menu soft key) to enter main menu.
2. Press or to select the Call Features menu.
3. Press or to scroll to Bandwidth Settings, and then press .
4. Select desired bandwidth from the pull-down list of Uplink Bandwidth.
If Auto is selected, the endpoint will negotiate the appropriate bandwidth automatically.
5. Select desired bandwidth from the pull-down list of Downlink Bandwidth.
If Auto is selected, the endpoint will negotiate the appropriate bandwidth automatically.
6. Press (Save soft key) to accept the change.
Note
Bandwidth is configurable via the web user interface at the path Setting->Call
Features->Uplink Bandwidth/Downlink Bandwidth.
The actual bandwidth depends on the performance of the remote endpoint, and is affected by
the quality of the communication channel.
The priority of bandwidth is as follows:
System bandwidth> Contact bandwidth (refer to Adding Local Contacts).
For example: the system bandwidth is 512kbps, if contact bandwidth is set to a value greater than
512bps, then the actual contact bandwidth will be 512bps. If contact bandwidth is set to a value
less than 512bps, then the actual contact bandwidth will be the value set by user.
To Next Page
Loading...
