ZKTeco SpeedFace-V3L User Manual

SpeedFace-V3L User Manual
Page | 12 Copyright©2022 ZKTECO CO., LTD. All rights reserved.
experienced technical personnel.
Note:
 Make sure whether the positive polarity and negative polarity of the DC
12V power supply is connected correctly. A reverse connection may
damage the device. It is not advisable to connect the AC 24V power
supply to the DC 12V input port.
 Make sure to connect the wires following the positive polarity and
negative polarity shown on the device's nameplate.
 The warranty service does not cover accidental damage, damage caused
by mis-operation, and damage due to independent installation or repair
of the product by the user.

ZKTeco SpeedFace-V3L Specifications

General

Display type	LCD
Screen shape	Flat
Built-in display	Yes
Display diagonal	2.4 \
Display size (HxV)	240 x 320 mm
Internal memory	256 GB
Processor cores	2
Internal storage capacity	512 GB
Operating system installed	Linux
Type	Face recognition terminal
Access code reader	-
Authentication type	Biometric, Face recognition
Access chip/card reader	No
Face recognition distance	0.5 - 2 m
False Rejection Rate (FRR)	0.02 %
False Acceptance Rate (FAR)	0.01 %
International Protection (IP) code	IP65
Operating temperature (T-T)	-5 - 45 °C
Total megapixels	1 MP
RS-485 ports	1
Package weight	800 g

Weight and Dimensions

Depth	58.5 mm
Width	185 mm
Height	20 mm
Weight	300 g