Setting up the light curtain
80
Height of the bottom light beamCutter
h1 (items 1 and 3)
[mm]
h2 (items 2 and 4)
[mm]
max. 680 max. 680
Cutter with material transport
and CE
min. 640
max. 680
min. material
thickness
max. 120
1 Mirror 4 Light barrier transmitter/receiver
2 Holder 5 Clamping screw
3 Screw 6 Retaining bracket
A Slightly loosen the clamping screws of the retaining brackets on the light barrier transmitter (2x).
B Set the lowest light beam of the light barrier transmitter to the required height (the lenses are visible
in the light barrier transmitter).
C Retighten the clamping screws.
D Set the lowest light beam of the receiver to the required height (the lenses are visible in the
receiver).
E Average out the height of the deflection mirror (if present).
a) Loosen the screws on the brackets and adjust the height of the mirror.
b) Retighten the screws.
F Repeat the process on the second pair of pillars and the other three pillars with light barrier
transmitter/receiver.
To Next Page
Loading...
