Chapter 5 Initial Setup Example
XGS2220 Series User’s Guide
103
Figure 73 Initial Setup Example: Management IP Address
1 Connect your computer to any Ethernet port on the Switch. Make sure your computer is in the same
subnet as the Switch.
2 Open your web browser and enter “setup.zyxel” or “192.168.1.1” (the default IP address) in the address
bar to access the Web Configurator. See Section 4.2 on page 57 for more information.
Note: You can always use the domain name “setup.zyxel” to access the Web Configurator
whether the Switch is using a DHCP-assigned IP or static IP address. This requires your PC
to be directly connected to the Switch.
3 Go to the SYSTEM > IP Setup > IP Setup screen. Click Add/Edit.
The following screen appears.
To Next Page
Loading...
