ZyXEL Communications XGS2220 Series - Page 114

Chapter 6 Tutorials
XGS2220 Series User’s Guide
114
Setting Up the Switch
1 Open the Web Configurator. Go to the MAINTENANCE > Configuration > Auto Configuration screen.
Figure 76 Tutorial: Auto Configuration Screen
2 Enable the switch button in the Active field to enable auto configuration. Select DHCP in the Mode field,
and enter the VLAN ID where the DHCP server belongs to in the DHCP VLAN ID field. Click Apply to save
your changes.
Figure 77 Tutorial: Enable Auto Configuration
3 Go to the SYSTEM > IP Setup > IP Setup screen. Click the Add/Edit button in the IP Interface table to open
the configuration screen.
4 Select DHCP Client.
5 If you want to load the auto configuration file with DHCP option 60 enabled and a Vendor Class
Identifier assigned when you reboot the Switch, follow the instruction below. Otherwise, skip this step. In
the SYSTEM > IP Setup > IP Setup > Add/Edit screen, select the check box in the Option-60 field. Enter a
Vendor Class Identifier in the Class-ID field, and specify the VLAN interface in the VID field. In this
example, we use “ZyxelCorp” and VID 1. Click Apply.