3D Systems, Inc.
18
Material Storage
Build Material Support Material
Shelf life for VisiJet Build Materials with the
exception of HiCast & ProWax - 2 yr
Shelf life for VisiJet HiCast & ProWax - 5 yr
Shelf life - 5 yr
Climate - Cool, dry area with adequate venti-
lation
Climate - Cool, dry area with adequate ventila-
tion
Temperature Range - 60°F (16°C) to 80°F
(27°C)
Temperature Range- 60°F (16°C)to 80°F
(27°C)
Maximum Storage Temp - 95°F (35°C) Maximum Storage Temp - 95°F (35°C)
Environmental Conditions - No direct sunlight,
heat, ames, or UV energy.
Environmental Conditions - No direct sunlight,
heat, ames, or UV energy
NOTE: For optimal results, keep stored cartons closed and sealed until material cartridges are ready for use.
• Always check material “Recertication Date” before use. Do not
load material cartridges into printer if cartridge date has expired.
When printer detects an expired cartridge, it aborts the build and
rejects the cartridge.
• Support (white) material must be loaded in the left side of material
drawer. VisiJet part (black) material cartridges must be loaded in
the right side of material drawer. Before loading cartridges into
printer, inspect the cartridges for signs of damage or leakage. Do
not load a damaged or leaking cartridges. Dispose of material
cartridge according to local regulations.
Storing a Partially Used Material Cartridges
• It is important not to lay material cartridges that are partially used on their
side. Doing so will cause material to seep through the vent cap and clogging
cap. This will cause damage to the material cartridge if used for a later build.
• To store a partially used material cartridges, insert cartridge into a plastic bag
with the vent cap up; place cartridge into its original shipping carton’s sleeves
and carton. Do not remove a partially used Support Bottle from the MDM if
the MDM is NOT heating; the material will solidify and cause a breakage.
To Next Page
Loading...
Need help?
General
