3D Systems, Inc.
53
PRINTER STATUS REPORTING
Setting up Status INI File
• Before running the ModelerStatus.exe, a text le must be created that species the desired machine. See example below.
• The table below provides a description of the Printer Status INI parameters.
The ModelerBatch.exe application can be invoked from command line or program. The command line format is as follows:
• RootDir\bin\ModelerBatch.exe IniFile ReportFile
• Descriptions:
• RootDir - the installation folder of the ProJet client, which can be obtained from the registry by using:
• Key = “HKEY_LOCAL_MACHINE\SOFTWARE\3D Systems\3D Modeling Accelerator”
• Name= “RootDir”
• ReportFile - returns a report to a specied le on the job submission
NOTE: If a lename is not specied for the report le, the data will be written to a default le named ReportFile.txt.
This le will be overwritten every time the modelerbatch.exe or modelerstatus.exe applications are run without a
report le specied
The DOS window show below is an example of running the ModelerBatch.exe via command window.
Running the application
Section Name
Parameter
Name
Default Value
Description
JOB PROPERTIES IP Address NA IP address of the designated printer, e.g., 192.168.0.2 or
192.168.000.002
JOB - JobName NA The job names are not necessary to request current printer status.
However, individual job status will only be returned to the output
ReportFile if the job names are specied in the INI le.
The job name is formatted as “JOB - username@Computer-
Name-####”, where #### represents the 4-digit job number
To Next Page
Loading...
Need help?
General
