3D Systems ProJet 3500 Max Series User Manual

3D Systems, Inc.
61
STATUS AND MESSAGE LINES
MESSAGE CAUSE ACTION
ABORT • Abort button pressed. Select YES to abort or NO to cancel
the command.
ABORT ACKNOWLEDGED • You conrmed an abort command. The printer is
aborting the current job.
None.
BUILD PAUSED • PAUSE button pressed during the build. The
build platform moves forward and the chamber
door and waste drawer remain locked. When you
press PAUSE button during a build, the printer
completes its current task before stopping.
Press PAUSE to continue.
CLEANING PRINTHEAD • The printer is cleaning the build jets. None. (This occurs automatically
before every build.)
CLOSE DOORS • The chamber door is open. Close the chamber door
CONFIRM PLATFORM CLEAR OR
CANCEL
• The printer is prompting you to verify the platform
is clean and clear of obstructions. Refer to
installation of build platform.
Verify the platform is clean and clear,
then press YES to continue or press
Stop to cancel.
PRESS PAUSE TO CONTINUE • The printer is paused. Press PAUSE to continue or STOP to
cancel.
CYCLE POWER TO CONTINUE • A severe error occurred. The printer cannot
recover from it and must be switched off.
Cycle power to the printer. If the error
message occurs again, contact your
Technical Support Hotline.
DONE REMOVE BUILD • The printer completed building the current job. Remove the platform. Refer to
removal of build platform.
HOMING PRINTHEAD • The printer is initializing the Z-axis prior to
building.
None
HOMING X - Y
60
• The printer is initializing the X-axis and Y-axis prior
to building.
None
INSTALL PLATFORM • The printer cannot detect a platform. Install a clean platform.
NOT BUILDING • The printer is ready to build. Press Play to build on the Status
screen.
OK TO POWER OFF • The printer completed its internal shutdown
procedure and is ready to be shutdown.
Toggle power switch on printer rear
panel to the OFF position.
ONLINE/MENU? • The printer is ready to build. Press Play to build on the Status
Screen
PAUSE ACKNOWLEDGE • The PAUSE button was pressed. The printer is
acknowledging and complying with the command.
None
PLEASE WAIT • The printer is cooling to shutdown temperature. Wait for the printer to complete its
shutdown procedures. Refer to printer
shutdown.

3D Systems ProJet 3500 Max Series Specifications

General

Brand	3D Systems
Model	ProJet 3500 Max Series
Category	3D Printers
Language	English