3D Systems, Inc.
26
PRINTER SET-UP
WARNING: READ AND FOLLOW SAFETY GUIDELINES IN ELECTRICAL SAFETY. IGNORING THESE
GUIDELINES COULD RESULT IN DEATH, BODILY INJURY, OR PRINTER DAMAGE DUE TO ELECTRICAL
SHOCK OR FIRE.
CAUTION: Verify printer’s rear panel power switch is OFF. Connecting power with switch on can damage printer
and cause bodily injury or death due to sudden, unexpected mechanical motion.
POWER ON PRINTER
1. Plug printer power cord into printer’s rear panel socket (A) and into the facility’s grounded power outlet.
NOTE: If 200-240 VAC required, connect power cord to external transformer and then plug transformer power cord
into a grounded power outlet.
2. Place switch located at the rear of printer to the ON position (B).
3. Wait 4 hours for printer to warm up before bringing printer online.
NOTE: A shielded Ethernet
cable is required when
connecting from the printer to
the your computer.
15
A
B
To Next Page
Loading...
Need help?
General
