3D Systems ProX DMP 300 User Manual

763D SYSTEMS, INC. PN:80-D27 Rev.B
PREVENTIVE MAINTENANCE SCHEDULE
Maintenance not listed on this section is only allowed to be performed by 3D Systems-certied Customer Support Engineer.
ITEM SPECIFICATION
ONCE A
MONTH
EVERY 3
MONTHS
EVERY 6
MONTHS
EVERY YEAR
Air pressure Check : 5.5 bar X
Pinch valve pressure Check : 3.5<X<4 bar X
Gas pressure Check : 4 bar X
Gas ow Check : 10<X<15 l/min X
Unclogging systems pressure Check : 2 bar X
Sieve screen Clean X
Carriage Lubricate X
Gloves Check X
Front casings Clean X
Back casings Clean X
Exhaust lter Replace X
Chiller Clean X
Clamping lter
Inspect
Replace
X
X
Airlock lter Replace X
Silicon scraper Replace X
Vibrating channel enclosure Clean X
Chiller lter Replace X
Cabinet lter Replace X
Cabinets Clean X
Calibration Check X
3D Systems recommends having an additional annual printer service performed by 3D Systems-certied Customer Support
Engineer. Contact the 3DSystems hotline.
EVERY MONTH MAINTENANCE
The pressure and owrate controls are performed on the control
cabinet:
A
Compressed air pressure
B
Pinch valve pressure
C
Gas pressure
D
Gas ow
The unclogging pressure control is performed behind the main cabinet:
C
A
B
D
Unclogging pressure

3D Systems ProX DMP 300 Specifications

General

Brand	3D Systems
Model	ProX DMP 300
Category	3D Printers
Language	English