663D SYSTEMS, INC. PN:80-D27 Rev.B
CLOSING / OPENING PX CONTROL APPLICATION
1. Click on the button (1).
2. Click “Yes” on the “PX Control : Closing” message.
SHUTTING PRINTER DOWN
1. Click on the button (1).
2. Click “Yes” on the “PX Control : Shuttdown” message. The complet
shutdown of the machine takes about 30 seconds (shutting down the
system control). Then push the start button to switch off.
The shutting printer down procedure will only switch off the printer, it will not be de-energized. To de-
energize the printer, refer to the section "Powering down the printer" on page 66).
POWERING DOWN THE PRINTER
1. The printer must be at rst switched off (see section "Shutting printer down" on page 66).
2. Close the gas valve (1) and compressed air valve (2) on the supply cabinet.
3. Switch the locking key to position "0" on the external conrtols panel.
4. Switch off the two UPS (see "H. Supply cabinet" on page 33).
5. Turn off the main switch on the connection panel of the supply cabinet (3).
To relaunch the PX Control application, double-click on the icon “PX_Control”, from the desktop.
3
1
2
1
1
To Next Page
Loading...
Need help?
General
