Pannoramic 250 1.15 User’s Guide 4 Software Description
On this tab panel you can set identification features and profiles for slides as follows:
Features on the panel
1. Apply one profile to all slides.
• One profile is used for all slides in a batch.
• Current Profile is the profile that was loaded in Routine work / Scan Profiles.
• You can also select any other profile in the selection box.
2. Read barcode if no name is defined on the list.
• The barcode will be used as name for the virtual slide. This option will work only if
no name has been entered in the Names / Barcodes cell of the table.
3. Enable parsing of barcodes or defined names.
• You can define the output directory, the name and the profile to be used by
barcodes.
• The positions of the characters in the barcode are defined in the mask fields. It is
possible to define areas using the character '–'. Characters located at different
places of the barcode may be combined by using a comma.
• Mainly 2D barcodes are used for this purpose. It is possible to use 1D barcodes,
however, it can contain less information.
• You can create up to five subdirectories by the barcode.
• If you use long strings for defining the profile name, select Match only the
beginning of the profile name. This makes profile coding faster.
Note:
Make sure that only one profile name begins with those characters.
Example for character string analysis
• Character string: Pannoramic_250F_123
• Mask: 1-10 = Pannoramic
• Mask: 12-15 = 250F
• Mask: 1-10, 17-19 = PANNORAMIC123
March 13, 2012 – Rev. 1 3DHISTECH Ltd.
72(135)
To Next Page
Loading...
