126
Wideband - Full Test
Wideband - Basic Test
The Wideband - Full Test includes a resistive balance
test (using special resistance) that requires a different
test lead connection. When this part of the Autotest
is reached, the user will be requested to swap the
black and green test leads or to skip this test.
To run this test after the leads have been swapped,
press the [Enter] key. To skip this test (and not
change the test lead connection), press the [Tab]
key. If the resistive balance test is run, be sure to
properly reconnect the 965DSP test leads to the
original hookup when the test is complete.
To Next Page
Loading...
Need help?
General
