Application Interfaces
229
The SNMP Agent supports SNMP Traps after SNMP version 2. In case the SNMP Agent
cannot be accessed, the OpenCom 100 communications system stores up to 100 error
or status messages. Also note that there is a SNMP description file (MIB, Management
Information Base) for the OpenCom 100 communications system which can be found
on the product CD.
Installing SNMP Agent
Install the SNMP Agent on a Windows PC. Select a PC which is usually in continuous
use, e. g. a Windows server.
1. Log on to the PC as a user with administrator rights.
2. Start the installation program for the SNMP Agent (file name:
“Aastra_CS_Setup.exe”). The program is on the product CD in the …\Aastra
directory.
3. Follow the steps of the installation assistant. In the Choose Components step
deactivate all components except for the SNMP Agent component.
4. As you continue with the installation assistant the IP address step is now dis-
played. Enter the IP address of the OpenCom 100 communications system.
5. Terminate the installation assistant with the Next, Install and Finish buttons.
During installation a Windows service “Aastra Call Server Supervisor Service” is con-
figured. This service starts the SNMP Agent. This means that the SNMP Agent is auto-
matically started with Windows and runs in the background, even when no Windows
user is logged on.
Configuring SNMP
The SNMP Agent requires the IP address of the SNMP Manager for operation. System
messages in the form of SNMP Traps are sent to this IP address. You manage the IP
address of the SNMP Manager in the OpenCom 100 communications system configu-
rator.
1. Start the web console of the OpenCom 100 communications system.
2. Navigate to the Telephony page in the Configurator: Settings. Click on the
Change button.
To Next Page
Loading...
Need help?
General
