Fixed Mobile Convergence
189
For users whose mobile telephones have the “Aastra Mobile Client” software installed
on them, there is a separate user guide available: “Fixed Mobile Convergence – Using
mobile telephones on the Aastra 800 / OpenCom 100 communications system”.
The user can set important system features, e. g. enquiry, call diversion, or call pro-
tection, by using code-number procedures. The code-number procedures are
described in the “OpenCom 100 / Aastra 800: Operation on Standard Terminals” user
guide.
The documentation is available as a PDF file on the OpenCom 100 communications
system product CD.
Configuring FMC Telephones
The following steps are for activating the FMC feature and to configure FMC tele-
phones:
1. In the Configurator of the OpenCom 100 communications system, call up the
menu page System:Licences.Check to see whether the Aastra Mobile Client
entry has a green checkmark next to it, indicating there is a valid licence. Oth-
erwise you have to authorise the feature first.
2. Call the Telephony: Devices: FMC Phones menu page. Click on the Change
button. Enter an internal call number into the FMC Phone No. field which a
mobile telephone uses to dial into the communications system. Or you may enter
another internal FMC call number into the MWI Signaling phone number field
for signalling calls from the communications system. Confirm with Apply.
These call numbers can usually be reached as extension numbers from external
sources or be called from external sources via the system connection. On the
Telephony: Call Distribution menu page, check the settings for the Incoming
DDI and Outgoing DDI call distribution, and assign extension numbers to the
FMC call numbers as needed.
Note
You should create an “FMC” user in the User Manager and assign the two FMC call
numbers to this user. MWI signalling requires the user belong to a user group with
external dialling authorisation.
To Next Page
Loading...
Need help?
General
