Configuration
89
Set NET Mask
H *183 Z (system PIN) *
Z (www) * Z (xxx) * Z (yyy) * Z (zzz) #
Example
Enter:
H*182
0000*192*1 68*99*254#
If required, initiate a system restart with the following procedure:
Trigger Restart
H * 1 8 5 Z (system PIN) #
Use the PIN you entered in the dialogue box for initial access. The factory setting is
“0000”.
Receiving System Messages as E-Mail
Important events and errors are kept by the OpenCom 100 in an internal log book: the
error store. To inform or alert the system administrators, entries in the log book
(system messages) can be sent via e-mail.
In order not to notified of every error, the administrator can define corresponding log
filters (in the Configurator, the Diagnosis: Log Filter menu). These filters define
which errors (category, severity, number per time interval) should be notified. The e-
mails always include an internal event or error number, as well as an explanation of
the message. Further, extra parameters (such as the port number when a trunk line
drops out) are also provided.
The mail account for this service (Account for LOG filter) is configured in the Config-
urator, Network: E-Mail menu.
Loading SW Updates
New versions of the system and terminal software can be loaded to the system.
New software versions of the OpenCom 100 are loaded from the configuration PC,
which accesses the Configurator (see the System: Firmware menu). For information
on connecting a configuration PC, see Brief Guide to Initial Configuration on page 80.
The terminal software is part of the OpenCom 100 software and is automatically
loaded into the terminals via the OpenCom 100 if the software version in the terminal
is different from the terminal software stored in the OpenCom 100.
To Next Page
Loading...
Need help?
General
