Program Interface Library AR_LOADSLV
CEI-100/CEI-200/CEI-x20 User’s Manual 113
ARS_HW_DETECT Failed to detect supported device.
ARS_MEMWRERR Error testing dual-port memory.
ARS_BRDNOTLOAD The i960 failed to start.
ARS_NO_INT_SUPPORT Internal interrupt handling was requested,
but is not supported by the board and/or
operating system.
ARS_INT_ISR Failed to install internal interrupt
handler.
ARS_ISR_ALREADY_INST Internal interrupt handling was requested,
but another process has already installed
an internal interrupt handler for the
board.
board (input) desired board number. The valid range for
this argument is 0-5 for CEI-100/200 devices, or 0-
15 for CEI-x20 devices. Under Windows, this
logical device id value was specified when the
software distribution was installed for the device in
question.
base_seg (input) base segment that the board is jumpered to,
if applicable (e.g., CC00 is the default for CEI-100
and D000 is the default for CEI-200/220/420). Set
this value to 0 under Windows (the base segment
value, if used, is automatically read from the
registry).
base_port (input) base port address that the board is jumpered
to, if applicable (e.g., 380 (hex) is the default). Set
this value to 0 under Windows (the port address
value, if used, is automatically read from the
registry).
For CEI-520/520A-xxJ configurations only: pass the
value AR_CEI520J_573_DISABLE to disable
573/717 operations and use all supported channels
for ARINC 429 traffic.
ram_size (input) size in Kbytes of the system memory space,
if applicable. The system’s size depends on the
configuration of the system purchased. The CEI-
100 size is either 4 or 8 K and the CEI-200 is either
16 or 32 Kbytes. Valid values are 4, 8, 16, and 32.
This value should be set to zero for all CEI-x20
boards.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...