Program Interface Library AR_RESET_INT
CEI-100/CEI-200/CEI-x20 User’s Manual 129
AR_RESET_INT
CEI_INT16 ar_reset_int (CEI_INT16 board);
This function resets an interrupt from the ARINC interface. This routine
should be called from your interrupt handler. It is applicable only to
interrupt-driven applications that have met the following conditions:
Set an interrupt jumper on the interface board (CEI-100/200 only).
Enabled interrupts with a call to AR_INT_CONTROL.
For the CEI-220/420, the function AR_INT_SET must have been called to
specify the interrupt number that is used by the board, since the CEI-
220/420 does not have jumper specified interrupts.
ARS_NORMAL Command was successful.
ARS_WINRTFAIL Command failed, WinRT error.
ARS_INVBOARD Board number out of range.
ARS_INVARG Board not initialized.
ARS_CHAN_TIMEOUT Firmware communications failure.
ARS_BOARD_MUTEX Failed to acquire/release the board lock.
board (input) board number of interest.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...