CEI-100/200 ARINC Test Program Hot Keys
CEI-100/CEI-200/CEI-x20 User’s Manual 44
/SA Loads the ARINC control program. The main program
then exits without entering the menu-driven functions.
/C name Loads a previously saved configuration of the specified
name when the program starts. A name must be specified.
All boards defined in the configuration (and only those
boards.) are automatically initialized.
Example 1
CONDOR /M D000 /I 388
In this example, the program assumes that the board was configured with
the dipswitch set to segment address D000 and the I/O address 388.
Example 2
CONDOR /C AVIATOR.CFG
In this example, the program starts running using the previously saved
configuration in file AVIATOR.CFG. This information includes the
segment address, I/O address, and RAM size of the board.
Previously saved configuration data can also be entered after starting the
program. The Setup menu provides this capability, as does the hot key
Alt-R.
Hot Keys
The following keys are short cuts that instantly activate a function when
hit during menu selection.
ALT-R – Restores a configuration from disk.
ALT-S – Saves current configuration to disk.
ALT-O – Sets Octal as the default radix.
ALT-X – Sets HEX as the default radix.
ALT-D – Spawns a DOS shell (type Exit when done).
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...