Connecting to an External Computer 11-5
11. Note the port number to which the analyzer is
assigned, and record this number. You will use this
port number later in this procedure.
(In the example at right, the port is COM4.)
12. Close the Device Manager.
13. Click Start > Run, and in the dialog enter
hypertrm.
This opens the HyperTerminal window.
14. In the Connection Description dialog, enter VS2, then
click OK.
15. In the Connect To dialog that opens, use the Connect
using pull-down menu to select the COM port you
found earlier.
16. Click OK.
To Next Page
Loading...
