Calibration and Quality Control 7-5
7. Enter an alternate ID (up to 14 characters), then press
Done.
8. The analyzer checks the rotor type, then begins processing the
sample with no further input.
9. The analyzer indicates when the sample is finished processing,
then automatically prints the results of the analysis.
If the results do not print automatically, they can be recalled
from memory and printed — see “Searching Results” on
page 6-3.
10. Press OPEN to open the rotor drawer, and remove the reagent
rotor from the drawer.
CAUTION: Dispose of the rotor according to the lab’s biohazard procedures.
11. When finished, press CLOSE to close the drawer.
To Next Page
Loading...
