ABB ACS800-104

External +24 V power supply for the RMIO board
75
External +24 V power supply for the RMIO board
What this chapter contains
This chapter describes how to connect external +24 V power supply for the RMIO
board.
When to use
External +24 V power supply for the RMIO board is recommended if
• the application requires fast start after connecting the input power supply
• fieldbus communication is required when the input power supply is disconnected.
For current consumption of the RMIO board, see chapter Motor Control and I/O
Board (RMIO).
Parameter settings
In Standard Application Program, set parameter 16.9 CTRL BOARD SUPPLY to
EXTERNAL 24V if the RMIO board is powered from an external supply.